3/3/2024 0 Comments Bathtub overflow washerThe water inlet valve requires a minimum of 20 psi to shut off properly. The water pressure to the water inlet valve might be too low. Then I switched from extra high water setting to low, and it continued to fill, no matter what water level, continued to fill, so I would say it's the Pressure Switch, yes?Īnything else I should try while out here in country house ? Thank you in advanceĬommon solutions for: Whirlpool Washer overflowing: I performed the steps below and when I unplugged it while filling w water, it shut off Check the water pressure to determine if it is sufficient. As a result, water can leak into the washer and cause it to overflow. If the water inlet valve does not get enough pressure, the valve may not close fully after the power is shut off. Before replacing the pressure switch, check the air tube to the pressure switch to ensure that it is clear of debris and is not leaking. If the pressure switch fails, the water inlet valve will continue to fill the washer tub with water, causing the washer to overflow. The pressure switch shuts off power to the water inlet valve when the proper water level is reached. If the water inlet valve is defective, replace it. If the washer continues to fill with water even when it is not getting power, this indicates that the water inlet valve is defective. Try shutting off power to the washer while the machine is filling with water. FOund these troubleshooting steps for an overflowing washer.I'll try these and hopefully they can help someone else too:Ĭommon solutions for: Whirlpool Washer overflowing
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |